FreeCLinker Home Flash
Disconnected

Recording Control

Camera type
Select the camera protocol. Reboot required to apply.
Camera matching
How to pick a camera when the preferred (last-connected) one isn't the only one found during scan.
Prevent camera wake-up
GoPro only. Don't connect to a camera whose advertisement shows it's asleep/powered-down — a BLE connection attempt would otherwise wake it. A manually selected camera below still connects regardless.
Stop recording on disarm
When off, the camera keeps recording regardless of FC arm state.
BLE debug logging
Log raw BLE TX/RX packets to the serial console (DJI/GoPro only). Verbose — leave off unless debugging.
Low power mode
Minimum BLE TX power (Wi-Fi TX power too, for Caddx Orca) — shorter range, but less RF interference with the flight controller's RC receiver. On by default. Reboot required to apply.
WiFi config AP
Auto-start this configuration access point when no camera is connected. Off = never auto-start (holding the BOOT button still forces it on).
s start delay
Disarm delay
Delay between FC disarm and stopping the recording. 0 = stop immediately.
ms

Camera Mode Switch

AUX Channel
RC channel monitored for camera mode switching. Set to Disabled if not used.
Mode when high (> 1500 µs)
Camera mode to activate when the AUX channel goes high. Returns to Video when low.

OSD Templates

Custom Message 1
Default: battery percentage
Custom Message 2
Default: recording state / elapsed time
Custom Message 3
Default: camera mode, resolution, FPS, stabilization
Custom Message 4
Default: remaining record time and SD free space
Available tokens: {bat} battery %  ·  {rec} recording state  ·  {recdur} recording duration  ·  {mode} camera mode  ·  {res} resolution  ·  {fps} frame rate  ·  {eis} stabilization  ·  {rleft} SD time left  ·  {rcap} SD space left

Betaflight 4.5 Compatibility

BF4.5 mode
Betaflight 4.5 has no Custom Message 1-4 OSD fields. When on, the OSD Templates above stop being sent and Pilot Name / Craft Name are used instead.
Pilot Name
Default: battery percentage. Sent only when BF4.5 mode is on.
Craft Name
Default: recording state / elapsed time. Sent only when BF4.5 mode is on.
Available tokens: {bat} battery %  ·  {rec} recording state  ·  {recdur} recording duration  ·  {mode} camera mode  ·  {res} resolution  ·  {fps} frame rate  ·  {eis} stabilization  ·  {rleft} SD time left  ·  {rcap} SD space left
>
Web Serial API is not available.
Please use Chrome or Edge (desktop).